必赢国际游戏登录

LED Start Tine & Flicker Test System


产品性能

○ LED Lamp “Start time” “Rise up” “Flicker” test solution
○ Voltage phase angle settable,SYNC Technology make it more accurate
○ Meet requirement of ERP1192/2012 2009/125/EC IEC60696

  • 产品介绍
  • 产品参数
  • 产品特征
  • 工作原理
  • 满足标准
  • 适用范围

    Luminous flux, illuminance, brightness is the most basic physical quantities of photometric measurement test, PM2000 fast multi-function photometer is a fast sampling instrument, adopts 12 bits, the highest sampling speed use A/D technology, which reach to 10MHz, to realize light source fast test, it can record sample waveform with computer. PM2000 used as a normal illuminometer, Can be widely used in luminance flux, brightness,illuminance such as photometry category testing and measurement.

    PM2000 LED启动上升测试.jpg

    System configuration

    PM2000 Multiphotometer,Integrating Sphere,Standard lamp,Optical fibre,19" cabinet,WL Serial power cource (DC),CHP500C  AC power source. 

    PM2000 LED启动上升测试报告.jpg


    >Light current measuring range: 0.005×10-3A—19999×10-8A(Measuring range for luminous flux depends on the sensitivity of light collector and detector)

    >User can calibrate and calibrate zero by the keys on front panel

    >12 bits A/D Convert accuracy, five digital tube display

    >Fourth gear ten times range automatic conversion

    >USB communication interface

    >Instrument level: grade one;

    >Sample rate:could be set,the fastest is 20kS/s

    >Record the width:need to cooperate with computer software,the width can  be set freely

    >Trigger mode: software trigger、external trigger

    >Rated work condition:    

       Temperature: 25±5℃

       Humidity: ≤85%R.H

       Power supply: AC110V±10V, 50Hz±1Hz

    >Allowable work condition:

       Temperature: 0-40℃

       Humidity: ≤90%R.H

       Power supply: AC110V±10V, 50/60Hz

    >Store condition:

       Temperature: -20~50℃

       Humidity: < 90%R.H

    >Dimension: Length ×height× width (385mm×115mm×340mm)

    >Power consumption: 15VA 

     


    Detector V (λ) correct level is high,Meet the requirements of national level

    Instrument zero stability, five digital display,high precision, good stability

    The parameters calibration directly by the user through the instrument Panel

    USB communication interface, fast connect to computer 

    Using the record mode, Combining with the PC software the sampling rate can achieve 20 k/s, which could achieve transient waveform measurement of light; 

    Equip with CHP-500C Zero voltage synchronous switch programmable precision frequency testing power supply and special software which reach the standard 

    of American Energy Star and EU ERP light source start-up time, Run up time, and flicker test requirement. 


    PM2000 LED启动上升测试工作原理图.jpg

    Meet requirement of ERP1192/2012 2009/125/EC IEC60696

    LED